https://pocketnc.com/collections/v2-10/products/copy-of-pocket-nc-custom-vise
I am designing an adapter to further offset the gripper jaws to bring smaller pieces of stock closer to the center of the B table. This way I can keep my end mill “length below holder” as short as possible, and not need to reposition the working piece and redo setup/offsets.
My question being, can someone share the dimensional placement of the M4 Set Screw Gripper Jaws? Also, what is the thread pitch of the M4 Set Screw Gripper Jaws?
- 6061 Aluminum Vise Set
- 1 M6 Clamping Screw
- 2 3/16in Sliding Dowel Pins
- 10 1/8in Dowel Pin Gripper Jaws
- 6 M4 Set Screw Gripper Jaws
- 1 M4 Mounting Fastener
- 2mm, 3mm, and 5mm Wrenches
I understand if the PNC team prefers not to share this information as IP. Just figured I would ask before designing a new vise gripper.
Thanks,
Ryan