Hello, I’m selling our lightly used V2-10 as we do not use it; in fact, it has not been touched in well over a year. It’s in excellent condition and everything works as it should. It was originally purchased directly from Pocket NC in 2021, and has been well taken care of in a professional prototyping shop. Asking $5500, local pickup is preferred, located in Seattle, WA. Full list of what’s included is below.
- Pocket NC Mill V2-10 (without Kinetic Control)
- Includes:
- ER11 Collet - 1/8"
- 1 Extended reach tool holder
- ER11 Collet Wrench
- Pocket NC Vise w/ hardware and B-table adaptor
- 3mm hex Wera driver
- 5mm, 4mm, and 2mm hex wrenches
- USB Cable
- Power Cord
- Includes:
- Pocket NC Enclosure (without safety switch)
- V2-10 Accessories
- Includes:
- ER40 Collet - 3/4"
- ER40 Collet - 1"
- ER40 Fixture for V2-10
- ER40 Fixture Wrench
- Edge Finder Tool Holder
- 3x Extended Reach Tool Holders
- 2x ER11 Collet - 1/8"
- ER11 Collet - 3/16"
- ER11 Collet - 1/4"
- V2-10 Tool Holder Rack
- Harvey Tool Endmills
- 0.125" x 0.187" LOC 1.25" Reach Sqr. 3 Flute (982208)
- 0.125" x 0.187" LOC 1.25" Reach Ball 3 Flute (966108)
- 1/8" x 5/8" LOC Hard MTL 1 Flute (52508)
- 1/16" x 5/16" LOC Soft MTL 1 Flute (51862)
- 0.125" x 0.5" LOC 45° Ball 2 Flute (27908)
- Includes:
