Hi All,
I bought a pocket NC v2-10 in dec 2021 and I have just started working with it now (please don’t ask why it took so long!).
I have been reading about the start up of the machine here: https://pentamachine.atlassian.net/wiki/spaces/KCUR/pages/1727725635/Kinetic+Control+Installation+Guide+-+Pocket+NC , and it says that the Kinetic Pocket NC control software and user interface can be installed in the machine. Is this necessary or it is an optional? I have started using the machine with the Kinetic controller via and IP address and it seems to do the job.
One other issue I have is that I am trying to send a test cutting file to the machine but the kinetic controller keep on showing a error message about the enclosure being open. The funny thing is that I don’t have a NC enclosure connected to the machine, but I handmade one which won’t be connected. How can I disable the enclosure setting?
Many thanks,
Eva