Where is a guide for setup on cylinders? My questions are similar to this person’s WCS and Zeroing for Cylinders - Fusion 360
Ive broken 4 end mills already trying to figure this out.
Can you detail the issue a little bit more? How are the cutters being broken? What part of the setup is the main trouble?
Regards
TP
Set WCS at the top of cylinder and using TCPC measure only Y offset.
Im trying to machine a 5/16" cylinder, I need it to tilt 90 degrees so the cylinder is parallel with the tool but the X,Y and Z axis always end up out in space or rams the end mill right into the stock. No matter how hard I try all three axis are off. The Penta course is worthless. I get no option in Fusion for TCPC when I want to post process.